Measure Cone-Shaped Bores
Cone-shaped bores are defined by the taper angle and the diameters at two specific measuring depths. The integrated depth stop positions the measuring axis at the exact depth.
You will measure angle, taper pitch, diameters D1 and D2, out-of-round, and TIR with this gage.
Measure Parallel Surfaces
240 Series angled and/or radius sleeve bottom is a stop to locate gage on shaft diameter or tapered parallel dimension.
SPECIAL GROUND TO PROFILE SLEEVES
240 Series sleeves
Custom shapes that will measure your irregular shaped hole.
Fax or e-mail Dyer your measuring requirements.
Typical profiles of irregular holes
